Dịch vụ & Phân phốiCâu 83 / 521
A single made rod electrode is measured at 40 ohms resistance to earth. The code requires that it be:
a.Left as is because 40 ohms is acceptable
b.Replaced with a copper water pipe
c.Bonded to the neutral only
d.Augmented with one additional electrode (or otherwise meet 25 ohms)
Giải thích
Per 250.53(A)(2), a single rod, pipe, or plate electrode that does not have a resistance to earth of 25 ohms or less must be supplemented by one additional electrode. Because 40 ohms exceeds 25 ohms, a second electrode is required; leaving it or bonding only to the neutral does not comply.
Trích dẫn luật: 2023 NEC §250.53Luyện miễn phí toàn bộ 521 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Under the 2023 NEC, the service supplying a dwelling unit must be provided with a:
- Which type of surge-protective device is permitted to be connected on the line side of the service overcurrent device (service disconnect)?
- A concrete-encased electrode (Ufer) must consist of at least 20 ft (6.0 m) of:
- Overhead service conductors (service drop) over a residential driveway with no truck traffic must maintain a minimum vertical clearance above grade of:
- The general minimum vertical clearance of overhead service conductors above a roof surface (voltage not over 300 V to ground) is:
- The point of attachment of overhead service conductors to a building must be at least what height above finished grade?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-10 Electrical Trade Examination · Quy trình kiểm tra