Thiết bị & Bình nước nóngCâu 174 / 360
When a T&P relief discharge terminates to an indoor location such as a floor drain or pan, an air gap is required. Where must that air gap be located?
a.At the point of discharge, so the pipe does not connect directly to a drain
b.Inside the water heater tank
c.Only at the water heater cold inlet
d.At the gas control valve
Giải thích
The relief discharge must terminate through an air gap at the receptor so it is never directly connected to the drainage system. A direct connection could siphon sewer gases or block discharge. The air gap keeps the relief outlet open to atmosphere and visible.
Trích dẫn luật: 2022 California Plumbing Code (CPC) §608.5Luyện miễn phí toàn bộ 360 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A plumber is routing the discharge from a water heater T&P valve. Which installation is code-compliant?
- How must a water heater relief valve discharge pipe flow to its point of discharge?
- The material used for a water heater T&P relief valve discharge pipe must be:
- Which of the following is prohibited on a water heater relief valve discharge line?
- California requires storage water heaters to be braced against earthquakes. What is the minimum number of straps required?
- When strapping a gas water heater, the lower seismic strap must be located:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-36 Plumbing Trade Examination · Quy trình kiểm tra