Thiết bị & Bình nước nóngCâu 186 / 360
A gas water heater is installed in a residential garage. To reduce the risk of igniting flammable vapors, the ignition source should generally be elevated above the floor by at least:
a.18 inches
b.6 inches
c.12 inches
d.30 inches
Giải thích
Gasoline and other heavy flammable vapors tend to settle near the floor of a garage. Elevating the ignition source, such as a pilot or burner, at least 18 inches above the floor reduces the chance of ignition. Listed flammable-vapor-ignition-resistant (FVIR) heaters may change the specifics, but the 18-inch elevation is the traditional rule.
Luyện miễn phí toàn bộ 360 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Where should a water heater pan drain terminate?
- A house has a water meter with a check valve installed on the service. What must be added at the water heater to control thermal expansion?
- Thermal expansion in a domestic hot water system is primarily caused by:
- A fuel-gas water heater installed in a small closet requires combustion air primarily to:
- An atmospherically vented gas water heater relies on which principle to move flue gases out of the building?
- Under current California requirements, a new residential water closet may use a maximum flush volume of:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-36 Plumbing Trade Examination · Quy trình kiểm tra