Đường ống gaCâu 242 / 360
What is the typical operating (manifold) pressure for a standard residential propane (LP) appliance?
a.About 10 to 11 inches water column
b.About 3.5 inches water column
c.About 2 psi
d.About 25 inches water column
Giải thích
Standard propane appliances operate at roughly 10 to 11 inches water column at the manifold, higher than natural gas at about 3.5 inches. This is why an appliance and its regulator must be matched to the correct fuel; installing a natural gas orifice on propane, or the reverse, is dangerous. Confirm the appliance rating plate and regulator spring for the fuel supplied.
Luyện miễn phí toàn bộ 360 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Which material is the traditional default choice for interior fuel gas piping in residential and light commercial work?
- A tankless natural gas water heater lists an input of 199,000 BTU/hr. Using 1,000 BTU per cubic foot, what gas demand must the branch supplying it be sized for?
- A building is served by an elevated-pressure (2 psi) gas system. What component is required near each appliance?
- Which statement about listed flexible appliance connectors is correct?
- A sizing table (0.5 psi drop, natural gas) shows that 3/4-inch schedule 40 pipe at a 40-foot run carries 170 cfh, and 1-inch pipe carries 320 cfh. A section must supply a 250,000 BTU/hr load over that 40-foot run. What is the smallest listed size that works?
- Where should the sediment trap be installed in relation to the appliance shutoff valve and the appliance gas control?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-36 Plumbing Trade Examination · Quy trình kiểm tra