Cấp nước & Phân phốiCâu 31 / 360
Two fixtures on a branch each require 4 gpm. If the branch is sized so the combined design demand (with diversity) is about 6 gpm rather than 8 gpm, what principle is being applied?
a.Static head correction
b.Thermal expansion
c.Demand (diversity) factor recognizing simultaneous-use probability
d.Velocity head recovery
Giải thích
Reducing the arithmetic 8 gpm to a design 6 gpm reflects the demand or diversity factor, which accounts for the low probability that both fixtures peak at exactly the same instant. Static head, thermal expansion, and velocity head recovery are unrelated to the simultaneous-use reduction.
Trích dẫn luật: 2022 California Plumbing Code (CPC) §610.0Luyện miễn phí toàn bộ 360 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Which standard covers seamless copper water tube types K, L, and M?
- On which fixtures does the code most specifically require water hammer arrestors?
- A pressure vacuum breaker (PVB) is selected for a landscape irrigation system. What is the minimum installation height for a PVB relative to the highest downstream head or outlet?
- For vertical copper water tube, how must risers be supported according to the support requirements?
- A commercial building connects to a boiler that uses chemical additives and is served from the potable main. What premise-isolation protection does the code generally require at the service?
- A fixture requires a minimum flow (residual) pressure of 8 psi to operate correctly. During peak demand your calculation shows only 5 psi available at that fixture. What is the correct interpretation?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-36 Plumbing Trade Examination · Quy trình kiểm tra