Cấp nước & Phân phốiCâu 59 / 360
A single check valve is proposed as backflow protection for a high-hazard chemical connection. Why is this not acceptable?
a.A single check is too expensive
b.A single check increases flow too much
c.A single check is not a tested, fail-safe assembly and provides inadequate protection for a health hazard
d.A single check cannot be installed horizontally
Giải thích
A single check valve is not a tested, redundant, fail-safe assembly, so it does not provide the reliability required for a health (high) hazard, which needs an RP or air gap. Cost, flow increase, and orientation are not the reasons a single check is disallowed for high hazards.
Trích dẫn luật: 2022 California Plumbing Code (CPC) §603.0Luyện miễn phí toàn bộ 360 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- To allow individual maintenance, where does good practice and code generally require shutoff (angle stop) valves in a dwelling?
- A two-story home has the main run in the crawlspace and risers to the second floor. To minimize pressure loss to upstairs fixtures during simultaneous use, which strategy is best?
- A dental office has vacuum and treatment equipment connected to the potable supply, presenting a health hazard with possible backpressure. Which premise-isolation assembly is appropriate?
- After installing a new RP assembly on a high-hazard connection, what ongoing requirement typically applies?
- Threaded steel (galvanized) water pipe is run horizontally. What is the typical maximum horizontal support spacing?
- A homeowner reports faucets that hammer and leak, and you measure 105 psi static. Besides installing arrestors at quick-closing valves, what is the primary corrective action?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-36 Plumbing Trade Examination · Quy trình kiểm tra