Type II — High-PressureCâu 132 / 240
A technician is checking the charge on a system equipped with a thermostatic expansion valve (TXV). Which measurement is the preferred way to verify the charge on a TXV system?
a.Subcooling at the condenser outlet (liquid line)
b.Superheat at the evaporator inlet
c.Suction pressure alone
d.Ambient temperature only
Giải thích
On a TXV system, subcooling is the preferred method to check the charge because the valve maintains evaporator superheat fairly constant. Subcooling is the difference between the liquid-line saturation temperature and the actual liquid temperature. Superheat is the main check on fixed-orifice systems rather than TXV systems.
Luyện miễn phí toàn bộ 240 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A technician performs triple evacuation on a Type II system. What gas is used to break the vacuum between evacuations?
- A technician is charging an R-410A system that uses a near-azeotropic blend. To keep the blend's composition correct, how should refrigerant be removed from the cylinder during charging?
- A technician checks the charge on an R-22 system that uses a fixed orifice (piston) metering device. Which measurement is the primary method to verify the charge?
- A technician fills a DOT recovery cylinder with recovered R-22. To prevent a dangerous hydrostatic rupture, the cylinder must not be filled beyond what fraction of its capacity?
- A technician needs to locate a small refrigerant leak on an R-22 condensing unit. Which method is a recognized leak-detection technique?
- A technician pressure-tests a repaired R-410A system for leaks before evacuating. Which gas is appropriate for pressurizing the system for a leak test?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với EPA Section 608 Technician Certification Exam · Quy trình kiểm tra