Type II — High-PressureCâu 139 / 240
A technician sets up push-pull recovery on a system with a large liquid charge. How does the push-pull method work?
a.The recovery machine pushes vapor into the top of the system while pulling liquid out the bottom into the recovery cylinder
b.It pulls only vapor from both service ports at once
c.It relies solely on the system's compressor to move liquid
d.It uses shop air to push refrigerant into the cylinder
Giải thích
In push-pull recovery, the recovery machine discharges vapor that pushes liquid refrigerant out of the appliance and pulls it into the recovery cylinder, moving a large liquid charge quickly. It is used only on systems with a substantial liquid charge, not on small ones. The method does not use shop air or rely on the system's own compressor.
Luyện miễn phí toàn bộ 240 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A technician notices R-410A gauge pressures running much higher than an equivalent R-22 system at the same conditions. What does this reflect about R-410A?
- A technician plans to retrofit an old R-22 system to an HFC blend that uses polyolester (POE) oil. Which statement about the retrofit is correct?
- A technician handles a high-pressure refrigerant cylinder in a hot truck bed in summer. Which practice is safest for storing and transporting the cylinder?
- A very-high-pressure appliance using R-13 must have its refrigerant recovered before service. Using recovery equipment made after November 15, 1993, what is the required evacuation level?
- A technician measures 12°F of superheat on a fixed-orifice R-22 system but the manufacturer's chart calls for 20°F at those conditions. What does the low superheat suggest?
- During recovery from a Type II system, a technician sees noncondensable gases (air) collected in the recovery cylinder. What is the correct handling under Section 608?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với EPA Section 608 Technician Certification Exam · Quy trình kiểm tra