Type II — High-PressureCâu 156 / 240
A technician retrofitting an R-22 system to an HFC replacement changes the oil and refrigerant. Which additional component is most commonly replaced during the retrofit?
a.The filter-drier
b.The evaporator coil
c.The condenser fan motor
d.The disconnect switch
Giải thích
During a retrofit, the filter-drier is commonly replaced to protect the new refrigerant and oil charge and to capture any residual moisture or contaminants. The metering device may also need adjustment or replacement. The evaporator, condenser fan motor, and disconnect are not routinely changed just because of a refrigerant retrofit.
Luyện miễn phí toàn bộ 240 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Before opening a Type II system for a compressor change, a technician recovers the refrigerant. Which sequence best protects both the technician and the environment?
- A technician performs a standing pressure (leak) test on a repaired Type II system using dry nitrogen. Over several hours the pressure holds steady with no drop. What does this indicate?
- A technician is selecting a vacuum pump to properly dehydrate a Type II R-410A system. Why is a dedicated vacuum pump used instead of the recovery machine to pull the final vacuum?
- A technician is unsure which required vacuum applies to a high-pressure appliance during recovery. Which two factors determine the required evacuation level?
- A technician recovers refrigerant from a heat pump in heating mode and is unsure which service port to use. On a heat pump, why must the technician understand the reversing valve position when recovering or charging?
- A commercial refrigeration appliance holds more than 50 pounds of an ozone-depleting refrigerant and has developed a leak. Under the Section 608 leak-repair requirements, what must the owner or operator generally do?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với EPA Section 608 Technician Certification Exam · Quy trình kiểm tra