Wiring Methods & MaterialsCâu 74 / 120
What is the maximum total amount of bend permitted in one run of EMT between pull points?
a.270 degrees
b.180 degrees
c.360 degrees
d.540 degrees
Giải thích
No more than the equivalent of four quarter bends, or 360 degrees total, is permitted between pull points such as conduit bodies and boxes, because friction rises sharply with each bend. The same 360-degree limit appears in the articles for rigid metal conduit and PVC, so it is worth memorizing once.
Trích dẫn luật: 2023 NEC §358.26Luyện miễn phí toàn bộ 120 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- At what maximum interval must Type MC cable be supported and secured?
- At what maximum interval must Type AC cable be supported?
- What is the maximum support spacing for a 1-inch trade size rigid PVC conduit?
- A cable passes through a bored hole in a wood stud. If the edge of the hole is less than 1 and 1/4 inches from the nearest edge of the stud, what is required?
- A pull box is used for a straight pull, and the largest raceway entering it is 3 inch trade size. What is the minimum required length of the box in the direction of the pull?
- An angle pull box has one 2-inch raceway and one 1-inch raceway entering the same wall, with conductors turning 90 degrees. What is the minimum distance from that wall to the opposite wall?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với Journeyman Electrician Licensing Exam (NEC-based) · Quy trình kiểm tra