Codes & SafetyCâu 103 / 120
A homeowner hires a plumbing company to replace a water heater and reroute the gas line to it. A journeyman employed by that company will perform the installation. Under a typical adopted plumbing code, who is authorized to apply for and hold the permit?
a.Any journeyman on the crew, because the journeyman is the person who performs and signs off on the installation
b.The licensed plumbing contractor responsible for the work, or the owner of a single-family dwelling where the jurisdiction allows an owner-builder exemption
c.The plumbing inspector, who issues the permit and holds it on the owner's behalf until the final approval
d.No one, because replacing an existing water heater is a like-for-like repair that never requires a permit
Giải thích
A permit is issued to the party who is legally responsible for the work, which is the licensed contractor, and many jurisdictions also allow an owner occupying a single-family home to pull a permit for work on that home. A journeyman performs the work under the contractor's license but is not the permit holder. The inspector enforces the code and approves the work; issuing a permit to himself would defeat that separation. Water heater replacement and any change to gas or water piping is permitted work, while truly minor items such as clearing a stoppage or swapping a faucet are the usual exemptions.
Trích dẫn luật: IPC §106Luyện miễn phí toàn bộ 120 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Underground drainage piping is installed, and the crew backfills and compacts the trench before the groundwork inspection is called for. What does the code require?
- Model plumbing codes are published on a three-year cycle. A state adopts one of those editions with statewide amendments, and a city then adopts the state code with additional local amendments. Which document governs an installation in that city?
- A drainage, waste and vent system is being water tested. Which statement describes the test correctly?
- A high-rise DWV system is water tested in sections. The highest joint in the section currently under test is 28 ft above the building drain, and three more floors of piping continue above that section. To what height above the building drain must the test standpipe extend?
- Freezing weather makes a water test impractical, so the DWV rough-in is air tested instead. Which combination of test pressure and duration satisfies the code?
- A water distribution system that will operate at 45 psi working pressure is tested with water. The plumber pumps it to 48 psi, and after 15 minutes the gauge reads 46 psi. How should the result be reported?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với Journeyman Plumber Licensing Exam (UPC/IPC-based) · Quy trình kiểm tra