InspectionPregunta 42 de 60
Before the leak-down (static) tests, to what pressure should the air system be brought?
a.About 20 psi
b.About 45 psi
c.About 60 psi
d.Governor cutout, about 125 psi (fully charged)
Explicación
Before performing the applied and released leak-down tests, the system should be fully charged to about governor cutout pressure (around 125 psi). Starting from full charge gives an accurate measure of how much air leaks out over one minute. Testing from a low pressure would not reveal the true leak rate.
Practica las 60 preguntas gratis — sin registro.
Preguntas relacionadas de este tema
- Why should you drain the air tanks and check for oil or water before a trip if the tanks do not have automatic drains?
- During the pre-trip air brake check, when should you check that the pushrod stroke is not too long?
- What does it mean if the low-pressure warning stays on after you start building air pressure?
- What is the correct order for the brake system portion of a pre-trip inspection regarding air build-up?
- If you find a lot of oil in the drained air from the tanks, what could this indicate?
- Why is it important to check that the governor cuts the compressor in and out at the correct pressures?
Última revisión: · proceso editorial
Equipo Editorial de PrepPass · Verificado con CDL Air Brakes Knowledge Test · Cómo revisamos