Vehicle InspectionPregunta 6 de 120
With the engine off and the air system fully charged, you begin fanning off air pressure with the brake pedal. At roughly what pressure should the tractor protection valve and parking brake valve pop out?
a.Between 60 and 80 psi
b.Between 10 and 15 psi
c.Between 80 and 100 psi
d.Between 20 and 45 psi
Explicación
Spring-brake control valves must pop out somewhere between 20 and 45 psi, applying the parking brakes automatically before the system loses the ability to hold the vehicle. Pressures of 60 to 80 psi or higher would mean the valve trips too early, and 10 to 15 psi would leave the vehicle without brakes at a dangerously low pressure.
Practica las 120 preguntas gratis — sin registro.
Preguntas relacionadas de este tema
- During your walkaround you measure 3/32 inch of tread on a drive-axle tire and 5/32 inch on a steer tire. What is the correct conclusion?
- At what air pressure must the low-air-pressure warning device on an air-brake vehicle come on?
- You are running the air-brake check with a fully charged system, engine off, and the service brakes released. What is the maximum allowable air pressure loss per minute for a combination vehicle?
- Which sequence correctly describes the seven-step inspection method?
- You finish a run in a property-carrying truck and discover the right rear turn signal stopped working during the trip. What must you do at the end of the day?
- Which set of emergency equipment must be on board a commercial motor vehicle?
Última revisión: · proceso editorial
Equipo Editorial de PrepPass · Verificado con Commercial Driver's License (CDL) General Knowledge Test · Cómo revisamos