Systems & CodePregunta 39 de 110
A closed water-supply system (with a backflow preventer or check valve at the meter) has a water heater but no expansion control. As the water heats and expands, what device is required to prevent pressure buildup?
a.A pressure-reducing valve
b.A vacuum breaker
c.A thermal expansion tank
d.A backwater valve
Explicación
A closed system cannot push expanded hot water back into the main, so a thermal expansion tank (or similar expansion control) is required to absorb the volume increase and prevent the T and P valve from weeping. Water expands roughly 2 to 3 percent between cold and hot, which spikes pressure in a sealed system. The expansion tank is charged to system static pressure.
Referencia Legal: UPC §608.5Practica las 110 preguntas gratis — sin registro.
Preguntas relacionadas de este tema
- A basement floor drain sits 3 ft below the elevation of the upstream sewer manhole cover. During a main surcharge, how much backpressure head could push up through that drain if unprotected, using 0.433 psi per foot?
- A hot-water recirculation loop loses 4,000 BTU/hr to the piping. The pump must circulate enough water so it cools only 20 F while replacing that loss. Using Q (gpm) = BTU/hr / (500 x delta-T), what recirculation flow is required?
- A temperature-and-pressure (T and P) relief valve on a water heater is rated to open at 210 F and 150 psi. What is the required disposition of its discharge pipe?
- A reduced-pressure principle (RP) backflow assembly is installed on a service subject to a health hazard. How must it be installed with respect to the ground and drainage?
- A lawn irrigation system with chemical injection is connected to a potable supply. This is classified as a high health hazard under backpressure and backsiphonage conditions. Which backflow assembly is required?
- An air gap is used to protect a potable outlet discharging over a flood-level rim. What is the minimum air gap for an effective opening of 1 in diameter, using the rule of two times the effective opening?
Última revisión: · proceso editorial
Equipo Editorial de PrepPass · Verificado con Master Plumber Licensing Exam (UPC/IPC-based) · Cómo revisamos