Network ImplementationCâu 98 / 100
Which Layer 3 switch feature provides a virtual interface used to route traffic for a VLAN without a separate router?
a.A trunk port
b.A native VLAN
c.A loopback plug
d.A switched virtual interface (SVI)
Giải thích
A switched virtual interface (SVI) is a virtual Layer 3 interface on a multilayer switch that routes traffic for an associated VLAN. This enables inter-VLAN routing entirely within the switch, avoiding router-on-a-stick. Each routed VLAN typically has its own SVI acting as the default gateway.
Luyện miễn phí toàn bộ 100 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- An administrator assigns 192.168.1.0/24 but needs subnets of varying host sizes. Which technique allows different subnet mask lengths within the same address block?
- Which DHCP component defines the range of IP addresses a server can lease to clients?
- A technician must extend a wired network into an area where running new cable is impractical. Which device bridges two network segments over the existing electrical wiring?
- Which SDN plane is responsible for making forwarding decisions and building the network's logical topology?
- An engineer configures a switch port that should immediately transition to forwarding for a single end host. Which STP feature is appropriate?
- Which type of NAT maps one private IP address to one dedicated public IP address permanently?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với CompTIA Network+ (N10-009) · Quy trình kiểm tra