Core TradesCâu 138 / 700
A standard plumbing trap must maintain a liquid seal with a depth in the range of:
a.2 to 4 inches
b.1/2 to 1 inch
c.5 to 7 inches
d.8 to 10 inches
Giải thích
A trap seal of 2 to 4 inches blocks sewer gas while resisting evaporation and siphonage. A shallower seal (under 2 inches) can be blown or evaporated away, letting gas into the building. A seal deeper than 4 inches tends to collect solids and self-siphon, and is not standard.
Trích dẫn luật: 2025 CA Plumbing Code §1002.0Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- For a 120/240-volt panelboard with no exposed live parts on the opposite side (Condition 1), what is the MINIMUM required clear working depth in front of the equipment?
- A concrete-encased electrode ('Ufer' ground) used as a grounding electrode must include at least how many feet of bare steel rebar or copper conductor encased in the footing?
- When calculating outlet box fill, how are the equipment grounding conductors entering a box counted?
- The primary purpose of a vent in a drain-waste-vent (DWV) system is to:
- A 3-inch-diameter horizontal drainage pipe should be installed at a MINIMUM slope of:
- The MOST reliable method to prevent backflow contamination of the potable water supply at a fixture is:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra