Finish TradesCâu 251 / 700
Which combination of assembly changes will BEST raise the Sound Transmission Class (STC) of an interior partition?
a.Using thinner drywall on both sides
b.Leaving the stud cavity empty and rigidly attaching both faces
c.Sealing all cracks with rigid mortar and adding no insulation
d.Adding cavity insulation, a second layer of gypsum, and decoupling one face with resilient channel
Giải thích
Sound isolation improves with added mass (second gypsum layer), absorption (cavity insulation), and decoupling (resilient channel) to break the vibration path. Thinner board, an empty rigidly attached cavity, or rigid connections lower STC by transmitting sound more directly.
Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- On long, continuous drywall walls and ceilings, control (expansion) joints are added to relieve stress. A common guideline places control joints in walls at a MAXIMUM spacing of about:
- A wall that will receive a high-gloss enamel or be raked by strong sidelighting typically requires the highest drywall finish. Under the industry levels of gypsum finish, that is:
- To reduce ceiling sag when a water-based spray texture will be applied, code and industry guidance generally require which gypsum board for ceilings framed 16 inches on center?
- On gypsum board joints, paper tape and mesh (self-adhesive fiberglass) tape behave differently. A key reason many finishers use PAPER tape at inside corners is that:
- When installing a window in an exterior wall with a weather-resistive barrier, the flashing should be lapped so that:
- A below-grade bedroom uses a window well to meet emergency escape requirements. The window well must generally provide a minimum horizontal area of at least ____, with a minimum projection and width of 36 inches.
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra