Finish TradesCâu 253 / 700
When installing a window in an exterior wall with a weather-resistive barrier, the flashing should be lapped so that:
a.The head flashing tucks behind the sill pan
b.All flashing is installed after the siding
c.Upper pieces lap over lower pieces (shingle fashion) so water drains outward
d.Only caulk is used, with no flashing
Giải thích
Flashing must be shingle-lapped, with the sill pan first, jamb flashing over the sill, and head flashing lapping over the jambs and tucked under the upper WRB, so water always sheds down and out. Reversing the laps, flashing after siding, or relying on caulk alone traps water and causes leaks.
Trích dẫn luật: 2025 CA Residential Code §R703Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- To reduce ceiling sag when a water-based spray texture will be applied, code and industry guidance generally require which gypsum board for ceilings framed 16 inches on center?
- Which combination of assembly changes will BEST raise the Sound Transmission Class (STC) of an interior partition?
- On gypsum board joints, paper tape and mesh (self-adhesive fiberglass) tape behave differently. A key reason many finishers use PAPER tape at inside corners is that:
- A below-grade bedroom uses a window well to meet emergency escape requirements. The window well must generally provide a minimum horizontal area of at least ____, with a minimum projection and width of 36 inches.
- Glazing that is adjacent to a door and within a certain arc of the closed door edge generally must be safety glazing. That arc is measured within a ____ radius of the door in the closed position and up to 60 inches above the floor.
- Glazing used in a guard or railing where people could fall against it must be:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra