Core TradesCâu 29 / 700
When strapping a tank-type water heater against seismic movement, the lower strap must be placed at least how far above the water heater's controls (thermostat/burner)?
a.1 inch
b.2 inches
c.3 inches
d.4 inches
Giải thích
The lower seismic strap must sit within the bottom third of the tank but at least 4 inches above the controls so it does not interfere with the thermostat or burner. Smaller clearances risk contacting the control area.
Trích dẫn luật: 2025 CA Plumbing Code (CPC) §507 (Water Heaters)Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- The drainage fixture unit (DFU) value assigned to a plumbing fixture PRIMARILY represents:
- A horizontal branch drain must carry fixtures totaling 14 drainage fixture units. If a 2-inch pipe is rated for up to 6 DFU and a 3-inch pipe for up to 20 DFU, what is the MINIMUM pipe size?
- A cleanout on a 4-inch drain line must have a MINIMUM clearance in front of it for rodding of about:
- When sizing fuel-gas piping to appliances, the two governing factors are the total gas demand (Btu/hr) and:
- A sediment trap (drip leg) installed in the gas supply just ahead of an appliance functions PRIMARILY to:
- A backwater valve on a building drain is required PRIMARILY where:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra