Core TradesCâu 32 / 700
A backwater valve on a building drain is required PRIMARILY where:
a.A fixture is on the top floor of a multi-story building
b.Fixtures are located below the level of the next upstream sewer manhole cover
c.The building has more than one cleanout
d.The water heater lacks a T&P relief valve
Giải thích
A backwater valve protects low fixtures that sit below the upstream manhole rim by preventing sewage from backing up into them during a surcharge. Top-floor fixtures, cleanout count, and water-heater valves are unrelated to this requirement.
Trích dẫn luật: 2025 CA Plumbing Code (CPC) §710 (Backwater Valves)Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- When strapping a tank-type water heater against seismic movement, the lower strap must be placed at least how far above the water heater's controls (thermostat/burner)?
- When sizing fuel-gas piping to appliances, the two governing factors are the total gas demand (Btu/hr) and:
- A sediment trap (drip leg) installed in the gas supply just ahead of an appliance functions PRIMARILY to:
- A vent pipe that penetrates the roof in an area without significant snowfall must extend at least how far above the finished roof surface?
- Shower and tub-shower control valves must be pressure-balancing or thermostatic types and are required to limit the water temperature to a MAXIMUM of:
- Flexible air ducts must be supported at MAXIMUM intervals of about what distance to prevent excessive sagging?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra