Core TradesCâu 34 / 700
Shower and tub-shower control valves must be pressure-balancing or thermostatic types and are required to limit the water temperature to a MAXIMUM of:
a.120 degrees F
b.130 degrees F
c.140 degrees F
d.150 degrees F
Giải thích
These anti-scald valves must cap outlet temperature at 120 degrees F to protect bathers from burns. The higher values would exceed the safe limit and defeat the purpose of the valve.
Trích dẫn luật: 2025 CA Plumbing Code (CPC) §408 (Showers)Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A sediment trap (drip leg) installed in the gas supply just ahead of an appliance functions PRIMARILY to:
- A backwater valve on a building drain is required PRIMARILY where:
- A vent pipe that penetrates the roof in an area without significant snowfall must extend at least how far above the finished roof surface?
- Flexible air ducts must be supported at MAXIMUM intervals of about what distance to prevent excessive sagging?
- An air-conditioning unit is rated at 36,000 Btu/hr of cooling capacity. Since one ton of cooling equals 12,000 Btu/hr, what is its capacity in tons?
- A cooling-coil condensate drain line must slope toward its point of discharge a MINIMUM of about:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra