Framing & StructuralCâu 349 / 700
To transfer shear from a diaphragm or wall into the framing, the connection of sheathing to the boundary members depends MOST on which factor?
a.The color of the sheathing
b.The nail size, spacing, and edge distance along the boundary
c.The brand of the lumber
d.The paint on the studs
Giải thích
Shear transfer at a boundary is governed by the fastening: nail size, spacing, and adequate edge distance along the boundary members determine how much shear the connection can move without splitting or pulling through. Sheathing color, lumber brand, and paint have no effect on shear transfer.
Trích dẫn luật: 2025 CA Residential Code §R602.3.1Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- In a seismic retrofit of an older house with a raised foundation, what two upgrades are MOST commonly added to the cripple wall and sill to resist earthquake movement?
- What is the main purpose of a hold-down (tie-down) anchor at the end post of a narrow shear wall?
- A 'collector' or 'drag strut' in a lateral system does what?
- Behind exterior cement plaster (stucco) applied over wood-based sheathing, how many layers of water-resistive barrier does the code generally require?
- A weep screed at the base of a stucco wall must be located at least how far above adjacent surfaces?
- CALCULATION: Cement plaster control joints are recommended to divide large wall areas into panels not exceeding 144 square feet. On a wall panel 8 feet tall, at about what horizontal spacing should control joints fall to stay within that limit?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra