Framing & StructuralCâu 375 / 700
A spiral stairway is permitted in a dwelling under special rules. Which requirement is characteristic of a code-compliant spiral stair?
a.Treads must be at least 11 inches deep at every point
b.Each tread provides a minimum run at a defined walk-line point (about 12 inches from the narrow edge) and headroom is at least 6 feet 6 inches
c.Risers may be any height with no limit
d.No center column is allowed
Giải thích
Spiral stairs are allowed with special geometry: the tread depth is measured at a walk line roughly 12 inches from the narrower edge and must meet a minimum there, with reduced but defined headroom of at least 6 feet 6 inches. Uniform 11-inch treads, unlimited risers, and a no-center-column rule do not describe a spiral stair.
Trích dẫn luật: 2025 CA Residential Code §R311.7.10.1Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A required stair handrail must be continuous along the flight. How should the ends of the handrail be treated?
- On a stair with solid risers and treads less than 11 inches deep, a nosing is required. What projection range does the code specify for that nosing?
- CALCULATION: Two stair carriages (stringers) are each cut from a 2x12 that is 14 feet long. Using nominal dimensions, how many total board feet of lumber is that?
- For a conventionally framed one-story dwelling using 2x4 studs, what is the MAXIMUM on-center spacing generally permitted for load-bearing wall studs supporting a roof and ceiling only?
- When installing tongue-and-groove wood structural panel subflooring, which practice BEST reduces squeaks and improves diaphragm performance?
- A gable roof has a total run of 12 feet (horizontal from wall to ridge) and a slope of 6:12. Ignoring ridge and overhang, what is the approximate line length of a common rafter along the slope?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra