SafetyCâu 570 / 700
On a 55 mph roadway you must close a lane and shift traffic 12 feet. Using the merging taper formula L equals W times S for speeds of 45 mph and above (L in feet, W in feet, S in mph), what is the MINIMUM taper length?
a.660 feet
b.60 feet
c.132 feet
d.396 feet
Giải thích
For posted speeds of 45 mph and above, the merging taper length L equals the offset width W times the speed S: L = 12 x 55 = 660 feet. Option b multiplies incorrectly. Option c and d use the wrong formula (the lower-speed version L = W x S squared / 60 applies only below 45 mph). Adequate taper length gives drivers enough distance to merge safely at higher speeds.
Trích dẫn luật: California MUTCD Part 6Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A worker must clear a jam inside a powered concrete mixer. What is the BEST practice to prevent the machine from starting during the work?
- On a construction site, what are the TWO commonly accepted ways to protect workers from ground faults when using temporary power for hand tools?
- Noise monitoring shows workers are exposed to an average of 88 dBA over an 8-hour shift. Beyond providing hearing protection, what is the employer generally required to establish?
- A flagger controls traffic at a work zone on a city street. Which practice BEST follows California MUTCD flagging guidance?
- A temporary traffic control zone is being set up. What is the PRIMARY purpose of the advance warning area with signs placed before the work?
- A large earthwork site keeps tracking mud onto the public street. Which best management practice (BMP) BEST addresses this under the site's storm water plan?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra