Lập kế hoạch & Dự toánCâu 369 / 521
The optional calculation method of 220.82 may be used for a dwelling served by a single 120/240 V feeder or service rated at least how many amperes?
a.60 A
b.100 A
c.200 A
d.400 A
Giải thích
The optional method applies where the dwelling is served by a single 3-wire 120/240 V (or 3-phase, 4-wire) service or feeder rated 100 A or greater. Smaller values do not meet the threshold and 200 A/400 A are not the minimum.
Trích dẫn luật: 2023 NEC §220.82(A)Luyện miễn phí toàn bộ 521 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A floor plan is drawn at a scale of 1/4 in = 1 ft. A wall measures 3 in on the drawing. What is its actual length?
- Which drawing best shows the vertical arrangement of the service and feeders as they run between floors of a multistory building?
- During the permit process, when is the rough (rough-in) electrical inspection normally performed?
- A 1,500 ft² dwelling's standard-method calculation yields 13,100 VA on 240 V (about 55 A). What is the minimum service disconnect rating required?
- When four or more fastened-in-place appliances (other than the range, dryer, space heating, and air conditioning) are on the same feeder in a dwelling, what demand factor may be applied to their total nameplate load?
- What is the minimum number of 20 A small-appliance branch circuits required to serve the kitchen, dining, and similar areas of a dwelling?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-10 Electrical Trade Examination · Quy trình kiểm tra