Kiểm tra & Khắc phục sự cốCâu 497 / 521
Testing a suspected conductor with an ohmmeter, you read 'OL' (over-limit / infinite). What does this indicate about the conductor?
a.A dead short (0 ohms) between the leads
b.A perfectly good, low-resistance conductor
c.An open circuit, the path is broken (infinite resistance)
d.Exactly 1 megohm of resistance
Giải thích
'OL' or an infinity display means resistance is beyond the meter's range, an open (broken) path with no continuity. A dead short reads near 0 ohms (a), a good conductor reads a very low value (b), and OL is not a specific finite value like 1 megohm (d).
Luyện miễn phí toàn bộ 521 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A terminal on a device is marked 'CU' only. What does this mean for terminations?
- A newly connected three-phase motor runs backward. What is the standard corrective action?
- A receptacle reads 120 V hot-to-neutral but 0 V hot-to-ground. Neutral-to-ground also reads 0 V and the ground pin has no continuity to the panel. What is the fault?
- In a properly bonded system, what is the primary purpose of the equipment grounding conductor during a line-to-enclosure (ground) fault?
- Before touching conductors you believe are de-energized, what is the safest way to verify your voltage tester is trustworthy?
- For routine voltage checks at 120 V cord-and-plug receptacle outlets on a branch circuit, what CAT rating is generally the minimum appropriate category?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-10 Electrical Trade Examination · Quy trình kiểm tra