Kiểm tra & Khắc phục sự cốCâu 514 / 521
Using the rule of thumb of 1 megohm minimum per 1,000 V of rating, what is the minimum acceptable insulation resistance for a 4,160 V motor?
a.0.24 megohms
b.1 megohm
c.416 megohms
d.About 4 to 5 megohms
Giải thích
The 1-megohm-per-kV guideline gives roughly 4,160 V / 1,000 = about 4.16 megohms, often rounded up (some add 1 megohm) to about 4-5 megohms minimum. Readings below this suggest degraded insulation. Option a inverts the ratio and c multiplies incorrectly.
Luyện miễn phí toàn bộ 521 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A non-contact voltage tester (NCVT) does not light up near a conductor you must work on. Before treating the conductor as dead, what is the correct action?
- A single-phase load operates at 240 V and draws 20 A at unity power factor. What is its power in kilowatts?
- Before connecting a three-phase motor to a new feeder, why would you use a phase-rotation (phase-sequence) meter on the supply?
- Why does over-torquing a lug or terminal screw create a hazard, even though the connection feels 'extra tight'?
- A homeowner reports that throughout the house, some lights dim while others brighten, and the effect shifts as loads switch on and off. Which service-level fault best explains this?
- Two meters are both marked CAT III, but one is rated 600 V and the other 1000 V. What does the voltage number add to the CAT rating?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-10 Electrical Trade Examination · Quy trình kiểm tra