Dịch vụ & Phân phốiCâu 89 / 521
Metal water piping system(s) in or attached to a building must be:
a.Left unconnected to avoid stray current
b.Used as the sole grounding electrode
c.Bonded to the service equipment enclosure, grounded conductor, or grounding electrode conductor
d.Connected only to the gas piping
Giải thích
Per 250.104(A), the interior metal water piping system must be bonded, with the bonding jumper sized per Table 250.102(C)(1) based on the service conductors. Metal water piping alone cannot be the sole electrode, and it must not be left unbonded or bonded only to gas piping.
Trích dẫn luật: 2023 NEC §250.104Luyện miễn phí toàn bộ 521 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- The point of attachment of overhead service conductors to a building must be at least what height above finished grade?
- A feeder supplies a single continuous load of 100 A. The minimum feeder conductor ampacity and overcurrent device rating is:
- A supply-side bonding jumper on the line side of the service, used to bond service raceways and enclosures, is generally sized based on:
- Ground-fault protection of equipment is generally required for solidly grounded wye services of more than 150 V to ground but not exceeding 1000 V phase-to-phase, where the service disconnect is rated:
- In a typical utility service arrangement, the electric meter (metering equipment) is normally connected:
- A feeder is the main power feeder to a single dwelling and carries the entire load. What allowance does the dwelling feeder provision give for sizing this conductor?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-10 Electrical Trade Examination · Quy trình kiểm tra