InstallationCâu 30 / 110
Refrigerant suction lines on a split system are typically insulated for what reason?
a.To add structural support
b.To prevent refrigerant leaks
c.To reduce heat gain and prevent condensation on the cold line
d.To increase line pressure
Giải thích
The suction line carries cold, low-pressure vapor, so it is insulated to limit heat gain that would reduce efficiency and to prevent surface condensation that drips and causes damage. The insulation should be continuous and properly sized. The liquid line is usually left uninsulated unless exposed to extreme heat.
Luyện miễn phí toàn bộ 110 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Why must condensate from a condensing furnace or cooling coil be routed to an approved drain?
- A secondary condensate drain pan or float switch is typically required when an air handler is installed where?
- When brazing refrigerant copper line sets, dry nitrogen is flowed through the tubing to accomplish what?
- What is the purpose of maintaining manufacturer-specified clearances to combustibles around a furnace?
- A properly installed refrigerant line set should have the liquid line and suction line sized according to what?
- On a long vertical suction riser, what feature helps ensure compressor oil returns properly?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-20 Warm-Air HVAC Trade Exam · Quy trình kiểm tra