Thiết bị & Bình nước nóngCâu 219 / 360
Water hammer arrestors are installed on a water distribution system primarily to:
a.prevent backflow
b.absorb the shock of quick-closing valves and reduce pipe noise and damage
c.raise system pressure
d.filter sediment
Giải thích
Quick-closing valves, such as those on clothes washers and dishwashers, cause a pressure surge (water hammer) that bangs pipes and can loosen joints. Water hammer arrestors provide a cushion of air or a piston to absorb that shock. They are installed near the quick-closing valve they protect.
Trích dẫn luật: 2022 California Plumbing Code (CPC) §609.10Luyện miễn phí toàn bộ 360 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A water heater must be installed so that:
- The temperature-sensing element of a water heater T&P relief valve must be located so that it senses:
- A thermal expansion tank installed on a water heater system must be:
- An outdoor hose bibb (sillcock) must be protected against backflow by:
- Each fixture supply to a lavatory or water closet is commonly fitted with an angle stop primarily to:
- A water heater installed in an attic must be reached by a passageway and working platform. A typical minimum requirement is a solid, continuous passageway not less than:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-36 Plumbing Trade Examination · Quy trình kiểm tra