Lập kế hoạch & Dự toánCâu 290 / 360
When sizing the water distribution system for a building, which CPC-recognized method bases pipe sizes on total demand expressed in water supply fixture units and available pressure?
a.Counting only the number of rooms
b.Matching the sewer pipe size
c.The fixture-unit sizing method using the code's sizing tables
d.Using the same size as the gas piping
Giải thích
CPC 610.0 sizes water piping using water supply fixture units (WSFU), developed length, and available pressure applied to the code's sizing tables. This translates fixture demand into required pipe diameters. Choosing the correct sizing method on the plan ensures adequate flow without oversizing.
Trích dẫn luật: CPC 610.0Luyện miễn phí toàn bộ 360 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A restaurant plan calls for eight identical mop-sink rough-ins. Each rough-in needs 1 P-trap, 1 trap adapter, and 2 drop-ear elbows. How many drop-ear elbows go on the takeoff?
- While laying out the building drain you reach a 90° change of direction. Under the CPC, what feature is generally required at such a change of direction on the horizontal drain?
- What is the main purpose of a plumbing fixture schedule on a set of plans?
- You must coordinate a 4-inch sanitary line and an HVAC duct that cross in a tight ceiling. What is the best planning step to resolve the conflict before installation?
- What does the term "top-out" refer to during the phases of a plumbing installation?
- On a plumbing plan you see three parallel lines each with a different break symbol: a single dash, a dash-dot, and a solid. What is the best way to know which system each represents?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-36 Plumbing Trade Examination · Quy trình kiểm tra