Type III — Low-PressureCâu 172 / 240
The 25 mm Hg absolute recovery requirement for low-pressure appliances applies to:
a.Only equipment made before 1993
b.Only equipment made after 1993
c.Only chillers over 200 pounds
d.All recovery equipment regardless of manufacture date
Giải thích
Unlike the high-pressure evacuation table, the low-pressure requirement of 25 mm Hg absolute is the same for recovery equipment made before or after November 15, 1993. There is no split based on equipment age or chiller size for low-pressure machines. This single deep-vacuum figure is a heavily tested Type III fact.
Trích dẫn luật: 40 CFR §82.156Luyện miễn phí toàn bộ 240 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Frequent operation of the purge unit on a low-pressure chiller is usually a sign that:
- A low-pressure refrigerant is defined as one with a boiling point at atmospheric pressure that is:
- Which gas is safe to use, along with a trace of refrigerant, to raise pressure in a low-pressure appliance for leak detection?
- Approximately what inches-of-mercury vacuum reading corresponds to the 25 mm Hg absolute recovery level for low-pressure appliances?
- Non-condensable gases such as air that collect in a low-pressure chiller will:
- Compared with older designs, a high-efficiency purge unit is desirable because it:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với EPA Section 608 Technician Certification Exam · Quy trình kiểm tra