Type III — Low-PressureCâu 174 / 240
Non-condensable gases such as air that collect in a low-pressure chiller will:
a.Lower head pressure and save energy
b.Raise head pressure and reduce efficiency
c.Have no effect on operation
d.Increase the refrigerant charge
Giải thích
Non-condensable gases collect at the high point of the condenser and raise head pressure, which forces the compressor to work harder and cuts cooling efficiency. That is why the purge unit exists. Rising non-condensables also point to an air leak on the vacuum side that should be repaired.
Luyện miễn phí toàn bộ 240 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Which gas is safe to use, along with a trace of refrigerant, to raise pressure in a low-pressure appliance for leak detection?
- The 25 mm Hg absolute recovery requirement for low-pressure appliances applies to:
- Approximately what inches-of-mercury vacuum reading corresponds to the 25 mm Hg absolute recovery level for low-pressure appliances?
- Compared with older designs, a high-efficiency purge unit is desirable because it:
- A technician wants to warm the refrigerant in a low-pressure chiller to speed recovery. Which method is acceptable?
- Low-pressure chillers most commonly use which type of compressor?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với EPA Section 608 Technician Certification Exam · Quy trình kiểm tra