Type II — High-Pressure第 159 / 240 题
A commercial refrigeration appliance holds more than 50 pounds of an ozone-depleting refrigerant and has developed a leak. Under the Section 608 leak-repair requirements, what must the owner or operator generally do?
a.Nothing, because leaks under 50 pounds are exempt
b.Vent the remaining charge and refill
c.Repair leaks when the appliance's leak rate exceeds the applicable threshold, or follow a retrofit/retire plan
d.Replace the refrigerant with air
解析
For appliances containing more than 50 pounds of an ozone-depleting refrigerant, owners and operators must repair leaks when the annual leak rate exceeds the applicable regulatory threshold, or otherwise follow a plan to retrofit or retire the equipment. Timely leak repair reduces refrigerant emissions. Venting is never an acceptable response to a leak.
法律依据: 40 CFR §82.156免费刷完整 240 道题库 — 无需注册。
同考点相关题目
- A technician performs a standing pressure (leak) test on a repaired Type II system using dry nitrogen. Over several hours the pressure holds steady with no drop. What does this indicate?
- A technician is selecting a vacuum pump to properly dehydrate a Type II R-410A system. Why is a dedicated vacuum pump used instead of the recovery machine to pull the final vacuum?
- A technician retrofitting an R-22 system to an HFC replacement changes the oil and refrigerant. Which additional component is most commonly replaced during the retrofit?
- A technician is unsure which required vacuum applies to a high-pressure appliance during recovery. Which two factors determine the required evacuation level?
- A technician recovers refrigerant from a heat pump in heating mode and is unsure which service port to use. On a heat pump, why must the technician understand the reversing valve position when recovering or charging?
- After evacuating a Type II R-410A system to a deep vacuum, a technician is ready to charge. Which practice supports an accurate final charge?