Vehicle InspectionPregunta 17 de 120
At what pressure should the air compressor governor normally cut out and stop pumping air?
a.Between 60 and 80 psi
b.Between 85 and 100 psi
c.Between 120 and 140 psi
d.Between 150 and 170 psi
Explicación
The governor typically cuts out somewhere between 120 and 140 psi and cuts back in around 85 to 100 psi. Cutting out at 60 to 80 psi would leave too little reserve, and 150 to 170 psi would over-pressurize the system.
Practica las 120 preguntas gratis — sin registro.
Preguntas relacionadas de este tema
- During the applied-pressure portion of your air-brake test, what does the low-pressure warning coming on at 55 psi tell you?
- During the static leak test you find air pressure dropping steadily and you can hear a hiss near the trailer air lines. What should you do?
- You start the engine with the air tanks nearly empty and watch the gauge. On a dual air system, roughly how quickly should pressure build from 85 to 100 psi at operating rpm?
- You are performing the tug test after coupling. What are you actually checking?
- Which wheel and rim condition requires the vehicle to be taken out of service?
- You notice oil or grease on the outside of a brake drum during your walkaround. Why does this matter?
Última revisión: · proceso editorial
Equipo Editorial de PrepPass · Verificado con Commercial Driver's License (CDL) General Knowledge Test · Cómo revisamos