Network ImplementationPregunta 26 de 100
When implementing inter-VLAN routing on a single router interface, what configuration is required?
a.Router-on-a-stick using subinterfaces with 802.1Q tagging
b.A separate physical router for each VLAN
c.Disabling all trunk links to the switch
d.Assigning every VLAN the same subnet
Explicación
Router-on-a-stick uses a single physical interface divided into subinterfaces, each tagged for a VLAN with 802.1Q, to route between VLANs. This avoids needing one physical interface per VLAN. A Layer 3 switch is an alternative that uses SVIs.
Practica las 100 preguntas gratis — sin registro.
Preguntas relacionadas de este tema
- An administrator is terminating a straight-through Ethernet cable using the T568B standard on both ends. Which pin arrangement starts the sequence?
- Which technology allows a switch to supply electrical power to devices such as IP phones and access points over the data cable?
- A wireless network must support the highest client density in a crowded office. Which deployment choice best reduces co-channel interference on 2.4 GHz?
- Which routing protocol is a link-state interior gateway protocol that uses cost based on bandwidth as its metric?
- An engineer configures a static route of last resort. Which destination and mask represent the default route?
- Which protocol prevents Layer 2 switching loops by placing redundant links into a blocking state?
Última revisión: · proceso editorial
Equipo Editorial de PrepPass · Verificado con CompTIA Network+ (N10-009) · Cómo revisamos