Drainage, Waste & VentPregunta 2 de 120
What is the maximum developed length permitted between the trap weir and the vent opening for a 1-1/2 in trap arm?
a.3-1/2 ft
b.2-1/2 ft
c.5 ft
d.6 ft
Explicación
The trap arm table allows 3-1/2 ft of developed length for a 1-1/2 in trap arm. 2-1/2 ft is the limit for a 1-1/4 in arm, 5 ft applies to a 2 in arm, and 6 ft applies to a 3 in arm, so each of those is the wrong row of the table.
Practica las 120 preguntas gratis — sin registro.
Preguntas relacionadas de este tema
- A horizontal 2 in fixture branch is installed at the code minimum slope. Over a developed run of 18 ft, how much total fall does the pipe have?
- Except for traps specifically designed as deep seal traps, what is the required liquid seal depth of a fixture trap?
- A 4 in building drain runs 96 ft from the last fixture connection to the point where it leaves the structure. Installed at the code minimum slope for its size, what is the total fall?
- A fixture drain serving a lavatory is 1-1/2 in in diameter. What is the smallest vent size that may serve it?
- A horizontal building drain changes direction with a fitting that turns the flow 90 degrees. What does the code require at that point?
- A 2 in trap arm serves a floor-mounted fixture. The trap weir is at elevation 0. What is the greatest amount the trap arm may fall before it reaches the vent connection?
Última revisión: · proceso editorial
Equipo Editorial de PrepPass · Verificado con Journeyman Plumber Licensing Exam (UPC/IPC-based) · Cómo revisamos