Core TradesCâu 118 / 700
In a mixed California climate, a vapor retarder placed on the WRONG side of the insulation can cause:
a.Higher R-value
b.Better air sealing
c.No possible harm
d.Trapped moisture and condensation within the wall, leading to rot or mold
Giải thích
A vapor retarder on the wrong side can trap moisture that condenses inside the assembly, causing rot, mold, and reduced insulation performance. It does not raise R-value, improve air sealing, or be automatically harmless; placement must follow the climate-appropriate design.
Trích dẫn luật: 2025 CA Energy Code (Title 24, Part 6)Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Around a new window, the correct flashing sequence to integrate with the WRB is generally:
- Behind exterior stucco or siding, a drainage gap or weep provision is often required so that:
- Fiberglass batt insulation is compressed and stuffed tightly around wiring and into a cavity that is too shallow. The effect on thermal performance is:
- CALCULATION: A ceiling requires R-49 insulation. If a certain blown insulation provides R-3.5 per inch, what minimum installed thickness is needed?
- A kickout (diverter) flashing is installed where a roof edge meets a vertical wall at the bottom of a roof-wall intersection. Omitting it commonly causes:
- Under normal ambient conditions, what is the MINIMUM period that standard structural concrete should be kept continuously moist to develop adequate strength and durability?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra