Finish TradesCâu 241 / 700
Before installing thin resilient flooring (such as luxury vinyl tile), the substrate flatness matters because the material is thin. A common flatness tolerance is no more than about 3/16 inch deviation in:
a.1 foot
b.10 feet
c.50 feet
d.100 feet
Giải thích
Resilient flooring guidance commonly requires flatness within about 3/16 inch in 10 feet (and 1/32 inch in 1 foot) so bumps and dips do not telegraph or cause failures. Measuring over 1 foot is too short for that tolerance, and 50 or 100 feet is meaninglessly long.
Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Stretch-in (tackless) carpet installation over cushion relies on gripper strips at the room perimeter. When placing those strips, the pins should point:
- Solid strip hardwood is being blind-nailed. The fasteners are typically driven at roughly a 45-degree angle:
- A moisture-sensitive engineered wood floor will be installed over a radiant-heated slab. To protect the flooring, the surface temperature of the floor is generally kept below about:
- Under the North American Architectural Woodwork Standards, three quality grades are defined. Between Premium and Custom, which grade is typically the LOWEST/most economical, used where appearance requirements are minimal?
- A run of tall cabinets meets a wall that is not perfectly straight. To make the cabinet side fit tightly against the wavy wall, the finish carpenter should:
- A stone countertop overhangs a base cabinet to form an eating bar. When the unsupported overhang exceeds roughly the material's safe limit (often about 10 to 12 inches for typical stone), the installer should:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra