Finish TradesCâu 243 / 700
A run of tall cabinets meets a wall that is not perfectly straight. To make the cabinet side fit tightly against the wavy wall, the finish carpenter should:
a.Force the cabinet against the wall and caulk the gaps
b.Cut the wall studs to match the cabinet
c.Leave a visible gap and cover it with a wide molding
d.Scribe the cabinet side (or a filler) to the wall contour and trim to that line
Giải thích
Scribing transfers the wall's irregular contour onto the cabinet side or a filler strip, which is then trimmed to that line for a tight, gap-free fit. Forcing and caulking looks poor, cutting studs is not the fix, and a wide molding is a crude cover-up rather than a proper fit.
Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A moisture-sensitive engineered wood floor will be installed over a radiant-heated slab. To protect the flooring, the surface temperature of the floor is generally kept below about:
- Before installing thin resilient flooring (such as luxury vinyl tile), the substrate flatness matters because the material is thin. A common flatness tolerance is no more than about 3/16 inch deviation in:
- Under the North American Architectural Woodwork Standards, three quality grades are defined. Between Premium and Custom, which grade is typically the LOWEST/most economical, used where appearance requirements are minimal?
- A stone countertop overhangs a base cabinet to form an eating bar. When the unsupported overhang exceeds roughly the material's safe limit (often about 10 to 12 inches for typical stone), the installer should:
- Wall cabinets and grab-bar-ready walls rely on solid backing. When mounting heavy wall cabinets, the fasteners should be driven:
- During cabinet installation, a narrow gap remains between the last cabinet and a side wall or an appliance. The clean, professional way to close that gap is to use:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra