Finish TradesCâu 242 / 700
Under the North American Architectural Woodwork Standards, three quality grades are defined. Between Premium and Custom, which grade is typically the LOWEST/most economical, used where appearance requirements are minimal?
a.Premium
b.Custom
c.Economy
d.Marine
Giải thích
NAAWS defines Economy, Custom, and Premium grades; Economy is the lowest and is used where cost drives the work and appearance is not critical. Premium is the highest, Custom is the common default, and Marine is not a NAAWS grade.
Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Solid strip hardwood is being blind-nailed. The fasteners are typically driven at roughly a 45-degree angle:
- A moisture-sensitive engineered wood floor will be installed over a radiant-heated slab. To protect the flooring, the surface temperature of the floor is generally kept below about:
- Before installing thin resilient flooring (such as luxury vinyl tile), the substrate flatness matters because the material is thin. A common flatness tolerance is no more than about 3/16 inch deviation in:
- A run of tall cabinets meets a wall that is not perfectly straight. To make the cabinet side fit tightly against the wavy wall, the finish carpenter should:
- A stone countertop overhangs a base cabinet to form an eating bar. When the unsupported overhang exceeds roughly the material's safe limit (often about 10 to 12 inches for typical stone), the installer should:
- Wall cabinets and grab-bar-ready walls rely on solid backing. When mounting heavy wall cabinets, the fasteners should be driven:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra