Framing & StructuralCâu 337 / 700
CALCULATION: An engineered LVL header is specified as a 3-1/2 inch wide member built up from plies that are each 1-3/4 inch thick. How many plies are laminated together?
a.1 ply
b.2 plies
c.3 plies
d.4 plies
Giải thích
Total width divided by ply thickness: 3.5 / 1.75 = 2 plies. A single 1-3/4 inch ply gives only 1-3/4 inch, three plies give 5-1/4 inch, and four plies give 7 inch, none of which equals the specified 3-1/2 inch width.
Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- What minimum bearing length is commonly required at the ends of engineered wood floor members unless the manufacturer specifies otherwise?
- At the ends of I-joists that rest on a wall, a continuous member closing the joist ends and transferring vertical/lateral load is called what?
- Where a concentrated load (such as a post from above) bears down over an I-joist at a support, what is often installed to carry that load past the joist without crushing it?
- Engineered rim board is often chosen over solid sawn lumber at the perimeter of an I-joist floor mainly because it:
- Compared with solid-sawn joists, why are field notches and unauthorized holes especially damaging to engineered wood products such as I-joists and LVL?
- On braced/shear walls, code requires a plate washer at each anchor bolt between the sill plate and nut. A common minimum size is:
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra