Framing & StructuralCâu 400 / 700
A common rafter has a horizontal run of 10 feet and a rise of 5 feet. What is the roof slope expressed as unit rise per 12 units of run?
a.3:12
b.4:12
c.6:12
d.12:12
Giải thích
Slope in rise-per-12 equals (rise / run) x 12 = (5 / 10) x 12 = 6, so the slope is 6:12. 3:12 and 4:12 are shallower than the actual ratio, and 12:12 would require the rise to equal the run.
Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- When a plumbing or mechanical run requires boring holes in load-bearing wall studs, the code limits bored hole diameter to no more than what fraction of the stud depth for a bearing wall?
- For exterior wood decks, which material designation BEST indicates lumber suitable for the wet, ground-contact exposure of deck posts set near grade?
- In a braced wall line using wood structural panel sheathing, which nailing change MOST directly increases the shear capacity of the wall?
- In conventional roof framing with rafters bearing on exterior walls, what is the PRIMARY purpose of ceiling joists or an equivalent tie connecting opposing rafters?
- When anchoring wood ledgers or sill plates to masonry or concrete in a seismic design category, which fastener detail is MOST important for load transfer?
- On a residential stairway, the MAXIMUM allowable variation between the largest and smallest riser height within a single flight is generally limited to what value?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra