Framing & StructuralCâu 402 / 700
When anchoring wood ledgers or sill plates to masonry or concrete in a seismic design category, which fastener detail is MOST important for load transfer?
a.Using properly sized and embedded anchors with edge distance and spacing per the approved design
b.Relying on masonry nails driven by hand
c.Attaching with construction adhesive alone
d.Using a single anchor centered on the plate
Giải thích
Load transfer into masonry or concrete depends on correctly sized anchors installed to the design embedment, edge distance, and spacing. Hand-driven masonry nails, adhesive alone, or a single central anchor cannot develop the required capacity and violate the engineered detailing.
Trích dẫn luật: 2025 CA Residential Code §R606Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- In a braced wall line using wood structural panel sheathing, which nailing change MOST directly increases the shear capacity of the wall?
- A common rafter has a horizontal run of 10 feet and a rise of 5 feet. What is the roof slope expressed as unit rise per 12 units of run?
- In conventional roof framing with rafters bearing on exterior walls, what is the PRIMARY purpose of ceiling joists or an equivalent tie connecting opposing rafters?
- On a residential stairway, the MAXIMUM allowable variation between the largest and smallest riser height within a single flight is generally limited to what value?
- Behind exterior cement plaster (stucco) on a wood-framed wall, the code generally requires how many layers of an approved water-resistive barrier over the sheathing?
- Guards are required on a residential deck when the walking surface is located more than what height above the grade or surface below?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra