Framing & StructuralCâu 401 / 700
In conventional roof framing with rafters bearing on exterior walls, what is the PRIMARY purpose of ceiling joists or an equivalent tie connecting opposing rafters?
a.To support the finished roofing weight only
b.To provide attic storage capacity
c.To align the ridge board vertically
d.To resist rafter thrust that would otherwise push the walls outward
Giải thích
Ceiling joists or rafter ties act in tension to resist the outward thrust that sloped rafters exert on the walls at their bearing. They are not solely for roofing weight, attic storage, or ridge alignment; without the tie the walls could spread and the ridge could sag.
Trích dẫn luật: 2025 CA Residential Code §R802.4Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- For exterior wood decks, which material designation BEST indicates lumber suitable for the wet, ground-contact exposure of deck posts set near grade?
- In a braced wall line using wood structural panel sheathing, which nailing change MOST directly increases the shear capacity of the wall?
- A common rafter has a horizontal run of 10 feet and a rise of 5 feet. What is the roof slope expressed as unit rise per 12 units of run?
- When anchoring wood ledgers or sill plates to masonry or concrete in a seismic design category, which fastener detail is MOST important for load transfer?
- On a residential stairway, the MAXIMUM allowable variation between the largest and smallest riser height within a single flight is generally limited to what value?
- Behind exterior cement plaster (stucco) on a wood-framed wall, the code generally requires how many layers of an approved water-resistive barrier over the sheathing?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra