Framing & StructuralCâu 403 / 700
On a residential stairway, the MAXIMUM allowable variation between the largest and smallest riser height within a single flight is generally limited to what value?
a.1/8 inch
b.3/8 inch
c.3/4 inch
d.1 inch
Giải thích
Uniformity rules limit the difference between the largest and smallest riser (and largest and smallest tread) in a flight to no more than 3/8 inch, preventing trip hazards from uneven steps. 1/8 inch is stricter than required, while 3/4 inch and 1 inch exceed the limit and create dangerous inconsistency.
Trích dẫn luật: 2025 CA Residential Code §R311.7.5.3Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A common rafter has a horizontal run of 10 feet and a rise of 5 feet. What is the roof slope expressed as unit rise per 12 units of run?
- In conventional roof framing with rafters bearing on exterior walls, what is the PRIMARY purpose of ceiling joists or an equivalent tie connecting opposing rafters?
- When anchoring wood ledgers or sill plates to masonry or concrete in a seismic design category, which fastener detail is MOST important for load transfer?
- Behind exterior cement plaster (stucco) on a wood-framed wall, the code generally requires how many layers of an approved water-resistive barrier over the sheathing?
- Guards are required on a residential deck when the walking surface is located more than what height above the grade or surface below?
- Under conventional framing rules, deep solid-sawn floor joists (such as nominal 2x10 or 2x12) generally require blocking or bridging installed at intervals not exceeding what maximum spacing?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra