Framing & StructuralCâu 450 / 700
On a jobsite, prefabricated wood roof or floor trusses must NOT be treated in which of the following ways?
a.Handled with spreader bars to avoid bending during a lift
b.Braced permanently and temporarily as specified by the design
c.Cut, notched, or drilled through chords or webs to run a duct, without the truss designer's approval
d.Stored off the ground and kept from prolonged weather exposure
Giải thích
Truss members are engineered; cutting, notching, or drilling chords or webs without the designer's approval can void the design and cause collapse. Using spreader bars, following the specified bracing, and proper storage are all correct handling practices.
Trích dẫn luật: 2025 CA Residential Code §R502.11Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Where an exterior deck beam bears on a supporting post, what is the BEST practice for the beam-to-post connection?
- How many board feet are contained in 15 framing members that are each nominal 2x10 and 16 feet long? (Board feet per piece = nominal thickness in inches times nominal width in inches times length in feet, divided by 12.)
- Under the raised floor of a dwelling, short stud walls between the foundation and the first-floor framing (cripple walls) exceeding a nominal height must be braced primarily to resist what?
- A residential stairway must rise a total of 105 inches from finished floor to finished floor. Using the maximum allowable riser height of 7-3/4 inches, what is the MINIMUM number of risers, and the resulting even riser height?
- On a stairway that turns using winder treads, what is the MINIMUM tread depth measured at the walk line, and the MINIMUM depth at any point of the narrow end?
- On an open stair with a guard, the triangular opening formed by the tread, riser, and bottom rail is limited so that what size sphere cannot pass through?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra