Framing & StructuralCâu 451 / 700
A residential stairway must rise a total of 105 inches from finished floor to finished floor. Using the maximum allowable riser height of 7-3/4 inches, what is the MINIMUM number of risers, and the resulting even riser height?
a.13 risers at about 8.08 inches each
b.13 risers at about 7.75 inches each
c.14 risers at 7.5 inches each
d.12 risers at about 8.75 inches each
Giải thích
Divide 105 by the 7.75-inch maximum: 105 / 7.75 = 13.5, which rounds up to 14 risers because you cannot exceed the maximum. 105 / 14 = 7.5 inches per riser, within the limit. Thirteen risers would each be about 8.08 inches, exceeding the 7.75-inch cap; twelve risers at 8.75 inches also exceed the maximum.
Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- How many board feet are contained in 15 framing members that are each nominal 2x10 and 16 feet long? (Board feet per piece = nominal thickness in inches times nominal width in inches times length in feet, divided by 12.)
- Under the raised floor of a dwelling, short stud walls between the foundation and the first-floor framing (cripple walls) exceeding a nominal height must be braced primarily to resist what?
- On a jobsite, prefabricated wood roof or floor trusses must NOT be treated in which of the following ways?
- On a stairway that turns using winder treads, what is the MINIMUM tread depth measured at the walk line, and the MINIMUM depth at any point of the narrow end?
- On an open stair with a guard, the triangular opening formed by the tread, riser, and bottom rail is limited so that what size sphere cannot pass through?
- In conventional wall framing, where two members of a double top plate are spliced (joints occur), the upper and lower plate joints must be offset by at least how much?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra