SafetyCâu 664 / 700
CALCULATION: A trench 5 feet deep and 100 feet long requires a means of egress so no worker travels more than 25 feet of lateral distance to reach a ladder. What is the MINIMUM number of ladders needed, spaced so every point is within that distance?
a.2 ladders
b.1 ladder
c.4 ladders
d.5 ladders
Giải thích
Correct: with a 25-ft maximum lateral travel, one ladder covers 25 ft to its left and 25 ft to its right, i.e., a 50-ft span. A 100-ft trench therefore needs 100 / 50 = 2 ladders, positioned so their coverage zones span the length. One ladder covers only 50 ft (leaving the ends beyond 25 ft); 4 or 5 ladders exceed the minimum required.
Luyện miễn phí toàn bộ 700 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- A competent person classifies excavation soil by unconfined compressive strength. Which value range correctly identifies Type B soil?
- CALCULATION: A 6-foot-deep trench in Type A soil will be protected by sloping instead of shoring. Type A allows a maximum slope of 3/4 horizontal to 1 vertical (about 53 degrees). Measured from the trench bottom, how far back from the edge (horizontal run on each side) must the top of the slope extend?
- A contractor wants to use a benched (stepped) excavation wall as the protective system. In which soil is benching NOT permitted?
- Before mechanized digging begins, an excavator must have underground utilities located and marked. In California, what is the general requirement for notifying the regional notification center (DigAlert / 811)?
- Workers will enter a 7-foot-deep excavation next to a former solvent storage area where a hazardous atmosphere could exist. Under Cal/OSHA, what is required before and during entry?
- During lockout/tagout (LOTO) on a jobsite, several workers each apply their own personal lock to an energy-isolating device. Who is authorized to remove a given worker's lock?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB General Building (B) Trade Examination · Quy trình kiểm tra