Lập kế hoạch & Dự toánCâu 387 / 521
For a branch circuit, what maximum voltage drop does the NEC recommend for reasonable efficiency?
a.1%
b.10%
c.8%
d.3%
Giải thích
An informational note recommends that branch-circuit voltage drop not exceed 3% (with a combined feeder-plus-branch limit of about 5%). This is a recommendation for efficiency, not an enforceable rule, and the larger values would cause excessive drop.
Luyện miễn phí toàn bộ 521 câu hỏi — không cần đăng ký.
Câu hỏi liên quan cùng chủ đề
- Who is normally responsible for obtaining the electrical permit for a project?
- What is the primary purpose of a single-line (one-line) diagram?
- What information does a panel schedule provide?
- A dwelling's total calculated load is 44,000 VA on a 240 V service. What is the smallest standard service rating that will carry this load?
- Electric-vehicle supply equipment is considered a continuous load. At what percentage of its rating must the branch circuit and feeder be sized?
- A continuous load (operating 3 hours or more) draws 16 A. What minimum overcurrent-device/conductor rating must serve it?
Cập nhật gần nhất: · quy trình kiểm tra
Đội Ngũ Biên Tập PrepPass · Đối chiếu với California CSLB C-10 Electrical Trade Examination · Quy trình kiểm tra